Science Arts & Métiers (SAM)

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

Introduction Nomenclature CF: Carbon Fibers CFRP: Carbon Fibers Reinforced Plastics EOL: End-of-Life ILSS: InterLaminar Shear Strength LCA: Life Cycle Analysis rCF: Recycled Carbon

After describing the 3D angle-interlock composite studied in this work, in-plane tensile and shear tests conducted to determine the elastic modulus in both weft and warp directions and

It can also be seen that the higher fatigue strength of the 45°-B1 batch compared to the 90° batch is not in agreement with the pore size distributions measured on polished samples of

Random pattern speckle The methods that use a random pattern allow to study the displacement fields by temporal phase shifting methods interferometry or by digital image correlation DIC

The proposed proce- dure AK-ILS takes advantage of several points of the literature review: •the Hammersley sequence for the initial design of experiments, •the Kriging metamodel

Crack delamination appears at inclined drilling in the TBC at the BC/TBC interface at the leading edge but only from the second laser pulse when the laser beam interacts with the