Science Arts & Métiers (SAM)

2k 1A B1 D2L TEM = w L 3 where kw1 is the winding factor, AL A/m is the stator rms electric load, B1 T is the peak value of the fundamental of the magnets flux density at the stator

This can be explained by the fact that the sputtering rate of Al is higher than the Mo one.[10]Finally, as observed in the case of the Cr,AlN coatings and for the same reason, we

The equilibrium phase diagram of zirconium-hydrogen Zr-H system is relatively complex, as the formation of different hydride phases is dependent on hydrogen concentration and cooling

An equation is identified using the database to predict the transformation temperature Ms of a high entropy shape memory alloy as a function of its weighted chemical composition, which

Figure 2:Master curves identified on the experimental mass variation measured after time shifting to the reference temperatureθref= 150°C for a the ventilated oven and b saturated steam

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

In absence of particle retention, the residence time the time needed for a particle to travel a characteristic pore dis- tance is finite and was found to be an increasing function of

Thus, Eq.17gives a good approximation of the change in the crystallinity ratio for a given decrease of weight average molar mass as long as there are reasonable conver- sions of the