Science Arts & Métiers (SAM)

Thus, this harmonic, if exploited, can increase significantly the torque density of the machine[5].The main drawback of such configuration is the magnetomotive force MMF spectrum which

Figure 2:Master curves identified on the experimental mass variation measured after time shifting to the reference temperatureθref= 150°C for a the ventilated oven and b saturated steam

https://doi.org/10.1016/j.jclepro.2022.132785 Eco-design and medicine: Opportunities to implement eco-design in the pharmaceutical R & D process Duc-Nam Luua,b,c,*, Herv ´ e Gachetb,

https://doi.org/10.1016/j.tsf.2021.138782 Effect of carbon content on structural, mechanical and tribological properties of Cr-V-C-N coatings Linda Aissania,b, Akram Alhusseinc,*,

12 Evolution of von Mises Stress in SE a and SME b parts with maximal strain, of volume fraction of martensite in SE c and SME d parts with temperature depending on the length ratio,

Figure 19.Fractured surfaces of the samples: a after the quasistatic tensile test, b after the loading at 1 s−1, and c after the high strain rate tensile tests 100 s−1... Mechanics of

Conclusions The deposition of a 50% WC–Co–Cr/50% Colmonoy 88 coating onto a SAE 4340 steel substrate by thermal spraying gives rise to a deposit with a heterogeneous microstructure and

In this work, in addition to the study of the lattice parameters and the elastic strain evolution during an in-situ uniaxial tensile, we have brought out the preferential formation and