Science Arts & Mйtiers (SAM)

The scenario leading to these markers seems to be the same in the whole observed volume: the initiation phase is driven either by damage atfibre ends or a zone of confined matrix between

Thermal oxidation of vinyl ester and unsaturated polyester resins Juan Sebastian Arrietaa,b, Emmanuel Richauda,*, Bruno Fayollea, Fid ele Nizeyimanab aPIMM, Arts et Metiers ParisTech,

To show the influence that storage can have, two drying simulations with the same global surface area in both collectors were compared: one system without storage consisting of an air

As for conductivities, the optical band gaps obtained under the present experimental conditions do not seem to be dependent on the polymer chain lengths see Table 1 nor on the doping

New methodology of dynamical material response of dissimilar FSWed Al alloy joint under high strain rate laser shock loading Mohammad Ayada, Lucas Lapostollea, Alexandre

Adding fillers is known to increase the material stiffness see review1, increase its Mullins softening,2 and delay its fracture in monotonous loading3 as in fatigue.4Increasing the

As for FE_45 specimens, the crack density increase depending on tensile strain was found linear until specimen failure, because +45° and 45° layers have the same behaviour and composite

This so-calledweak inertia regimewas first obtained in the case of periodic homogeneous and isotropic media but was extended to the case of anisotropic ones with the restriction of