Science Arts & Mйtiers (SAM)

The scenario leading to these markers seems to be the same in the whole observed volume: the initiation phase is driven either by damage atfibre ends or a zone of confined matrix between

To show the influence that storage can have, two drying simulations with the same global surface area in both collectors were compared: one system without storage consisting of an air

Bennett and McDowell 2003 have used several mechanical quantities the maximum slip amplitude, an equivalent stress inspired by the Dang Van criterion Dang Van, 1973 and an equivalent

To simulate the adhesion of the reactive fluid on the mold surface, we developed a model to fix the fluid particles when they reached a certain viscosity and when they are exposed to a

Three points will be discussed: ➀the high oxidation rate of pDCPD in thin samples and the occurrence of degradation in thick samples where oxygen diffusion is the limiting step, ➁the

As for conductivities, the optical band gaps obtained under the present experimental conditions do not seem to be dependent on the polymer chain lengths see Table 1 nor on the doping

The lack of moist air and the sharp strain gradient on the one hand, and the higher stress triaxiality around an internal pore, on the other hand, cer- tainly make fatigue crack

Introduction Nomenclature CF: Carbon Fibers CFRP: Carbon Fibers Reinforced Plastics EOL: End-of-Life ILSS: InterLaminar Shear Strength LCA: Life Cycle Analysis rCF: Recycled Carbon