THE INFLUENCE OF SAMPLE STRUCTURE ON THE OPTICAL PROPERTIES OF SOLIDS

The workpiece surface roughness, and the roundness and diametral wear of the grinding wheel were measured after 10 grinding cycles, with each cycle comprising a 0.1mm advance of the

Classification of homogeneous oscillations of the spin system and of components of the strain tensor fi and of the electric polarization vector p under irreducible representations of

This study analyzed the influence of input parameters as belt speed (cutting speed), grit size and pressure on the output parameters as surface roughness, cutting force (sanding

Objective: This study aims to evaluate the influence of different air- abrasion pressures and subsequent heat treatment on the flexural strength, surface roughness,

As the same as in the yellow colour behaviour, in the red light shades (30 %) was observed that the amount of urea does not make too much significance in the values of K·S -1... In

The results of the surface roughness test showed that the Aura bulk fill resin showed a significant statistical difference between the initial roughness (control) and final

Hence, the purpose of this study was to determine degree of conversion of resin-based sealants and the effect of beverages on surface roughness and color change of

We provided evidence based on the emission spectra and the calculation of the experimental JO intensity parameters (Table 4) that the point symmetry around the Eu III can