[PDF] Top 20 Microtensile bond strength of CAD/CAM materials to dentin under different adhesive strategies

... aimed to evaluate the microtensile bond strength (µTBS) of novel computer-aided design/computer-aided manufacturing (CAD/CAM) restorative materials to ... See full document

... All adhesive systems used in this study are one-step self-etching adhesive materials containing various different monomers and ...due to its low viscosity and high ...monomers to ... See full document

... prepared to be cemented to a pre- polymerized resin composite ...section of the pre-polymerized resin composite (Lava Ultimate CAD - 3M ESPE - Seefeld, Germany), properly treated with ... See full document

... exposure of an area with a diameter of 4 mm of ...according to the type of adhesive used and hydratation stals: Group SB-wet: Single Bond 2 in wet dentin, Group SB- ... See full document

... use of adhesive materials has revolutionized many aspects of restorative and preventive dentistry ...mechanism to enamel and dentin is essentially an exchange process that ... See full document

... total of six extracted human teeth (n=6) were randomly distributed between two groups for bond strength testing, according to the different adhesive strategy used: Scotchbond ... See full document

... aim of this study was to evaluate the infl uence of Nd:YAG laser on microtensile bond strength (μTBS) of different adhesive materials to human ... See full document

... the adhesive systems tested or among the different adhesive strategies adopted for ScotchBond Universal, with the average bond strength ...Such bond strength values ... See full document

... order of ozone application and acid etching was changed in two of the study groups (Groups 2 and 3) to evaluate a possible change in ...protocol of phosphoric acid etching of ... See full document

... cleaned of gross debris and stored in distilled water at ...England), under cooling. The rest of enamel was removed with 400 grit silicon carbide abrasive paper in a polishing machine DPU-10 ... See full document

... aim of this study was to evaluate microtensile bond strength (μ-TBS) and failure mode of indirect composite restorations bonded to dentin using different ... See full document

... use of acid etchants to produce surface demineralization and collagen net- work exposure, allowing adhesive monomers interdiffusion and consequently the forma- tion of a hybrid layer, has been ... See full document

... care to leave one of their flat surfaces ...taken to a DP-10 polishing machine (Struers; Ballerup, Copenhagen, Denmark) and subjected to a sequence of 80-, 180- and 400-grit silicon ... See full document

... the bond interfaces between etch-and-rinse and self-etch techniques for Scotchbond ...etch-and-rinse adhesive system, the etching of the dentin with 35% phosphoric acid for 15 s causes the ... See full document

... beginning of adhesion use on dental substrates, and with the advancement of technology and scientific knowledge applied to dentistry procedures, the bond to dentin has still been ... See full document

... sound dentin presented the lowest bond strength, suggesting that certain supplementary demineralization may have increased the initial bond strength, probably due to the mild ... See full document

... & Bond 2.1), um “primer” autocon- dicionante (G2 Clearil SE Bond) e um adesivo autocondicionante (G3 One Up Bond F), através de resistência ao cisalhamento ao esmalte de dentes humanos, avaliando ... See full document

... type of dentin abrasion partially interfered on the self-etching adhesive systems performance, as described in previous studies [7, 9, ...the bond between the adhesive systems and the ... See full document

... viability of these studies and because of the difficulty in collecting sound human teeth, there is the necessity of finding a substrate similar to human ...similar to those of ... See full document

... comparison of microtensile bond strengths of several dentin bonding systems to primary and permanent ...microscopy of cut tooth surfaces and identification of ... See full document