• Nenhum resultado encontrado

Matéria (Rio J.) vol.22 número2

N/A
N/A
Protected

Academic year: 2018

Share "Matéria (Rio J.) vol.22 número2"

Copied!
10
0
0

Texto

Loading

Imagem

Table 1: Physical and mechanical properties of the carbon/glass hybrid thermoplastic composite rods
Figure 2: Typical cross-sectional images of the hybrids rods.
Figure  3  shows  the  typical  tensile  stress-strain  (σ-ε)  curves  for  the  hybrid  rods
Figure  4: Relation between the maximum applied stress and the number of cycles to failure, S-N curves for the hybrid  rods
+3

Referências

Documentos relacionados

The probability of attending school four our group of interest in this region increased by 6.5 percentage points after the expansion of the Bolsa Família program in 2007 and

In the present work the ballistic performance of MASs using coir fiber mantle, Figure 1, reinforced epoxy composites, as second layer, was for the first time compared to similar

The true protein digestibility of the whole corn was higher than that of the germ fraction (Table 5), probably due to differences in protein content (lower for corn) and dietary

Analisando cada ferramenta de forma pura e isolada, constata-se que o diagrama de Gantt é mais indicado quando se pretende monitorar e controlar o projeto e o

Immobilization has long been used to improve enzyme activity and stability in aqueous media, and, more recently, also in nonaqueous media (Bickerstaff, 1997; Bornscheuer, 2003),

Although the epoxy resin showed good interaction with the HAp, high polymer content was achieved and the flexural strength of the composite was higher than that of the original resin

Figure 4 shows the variation of the lexural rupture strength of the neat epoxy as well as the epoxy matrix composites reinforced with up to 30 vol% of continuous and aligned

A multilayered armor system (MAS), in which the conventional Kevlar ™ , following a front ceramic, was replaced by either an epoxy matrix composite reinforced with 30 vol% of