Science Arts & Métiers (SAM)

Considering nearly similar SLM conditions than those carried out on SLM machines, an increase of large spatters > 80μm with volume energy density VED was clearly demonstrated on a 316L

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

Relation between gloss and the roughness parameter It was shown in this investigation that, whatever the mor- phological texture of the polymer coating,: a the average curvature radius

Molar concentrations fields Prior to the molar concentration measurements, the absorptivity coefficient of each species in solution NaOH, HCl, and NaCl was carefully measured between

The novel kinetic model of AUN thermal aging was developed from a mechanistic scheme previously established for polyamide 11, by adding some extra paths of thermolytic alkyl radical

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

In absence of particle retention, the residence time the time needed for a particle to travel a characteristic pore dis- tance is finite and was found to be an increasing function of

Effect of Foam Bubble Size on Foam Rheology.In Figure 12, the results of apparent viscosity as a function offlow rate are compared in 1 mm GB main column, in which foam was pregenerated