Science Arts & Métiers (SAM)

Such a discontinuous behavior was also observed from the melt at a cooling rate of 10C min1in the PLA/talc sys- tem, but no explanation was given.40 The crystallization half time of

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

15and other torque scaling studies only deal with the case where only the inner cylinder rotates.12,13In that precise case, recent direct numerical simulations suggest that vortexlike

Laser surface melting of nickel-based alloy reduces nickel release in the primary cooling system of a nuclear power plant Wilfried Pacquentina,*, Lucille Goutona, Nad ` ege Caronb,

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

16 Schematic of the designed extrusion device to printing continuous carbon fiber reinforced PLA [38] Table 4 Statistic results of tensile and flexure strength of three different

The displacement represents the distance measured by DIC between two points located on the compression diagonal at 45◦to the rails passing through the centre of the shear area

elasto-plastic strain ep plastic strain tensor m Poisson’s coefficient rUTS ultimate tensile strength rY0.2 0.2% yield strength rF fracture stress r stress tensor req equivalent