Science Arts & Métiers (SAM)

In this paper, residual plastic strain distributions in the machined surface and subsurface, induced by the orthogonal cutting of OFHC copper under practical machining conditions

For all of these reasons, a Q4P1 shape function based on global DIC approach has been chosen for the present study, concerning the displacement field measurement during orthogonal

As a conclusion, depending on the morphology of sample 1, there are mainly three zones: Zone A, a solid zone in which the microstructure and the volume fraction of carbides are similar

The main conclusions regarding experimental investigation are listed below: - The uncut chip thickness influences mainly burr height - A transition uncut chip thickness, htr, is

The tests have shown a reduction in the cutting force, and have highlighted the impact of laser assistance on the integrity surface roughness, appearance, residual stress and the tool

Relation between gloss and the roughness parameter It was shown in this investigation that, whatever the mor- phological texture of the polymer coating,: a the average curvature radius

ROMP of novel hindered phenol-functionalized norbornenes and preliminary evaluation as stabilizing agents † Clémence Nicolasa, Jing Huangb, Emmanuel Richaudb, Wendy Minnec, Renata

Figure 19.Fractured surfaces of the samples: a after the quasistatic tensile test, b after the loading at 1 s−1, and c after the high strain rate tensile tests 100 s−1... Mechanics of