Science Arts & Métiers (SAM)

The optimisation is performed with NSGA-II algorithm which may choose technical parameters blade length, transmission ratio or electro-mechanical coefficient in this example to maximise

Manual assembly line developed at the Arts et Métiers Campus in Lille, with educational and industrial transfer objectives Taking up various concepts detailed in this chapter,

Ahmadi Institute of Mechanical Engineering I2M, TREFLE department, Arts et Métiers ParisTech - Talence, 33400 Key words: porous media, numerical simulation, inertial effects,

Keywords: Inspirational process, Case study, Conjoint Trends Analysis, CTA method 1 INTRODUCTION This paper describes a research project to model the cognitive processes of designers

Using a few preliminary cutting operations in various conditions, machined surfaces are measured and the effects of feed rate, depth of cut, cut- ting speed and insert nose radius are

This is why the co-design phase - including the conceptual, ar- chitectural and detailed design - should allow adding some constraints of appreciation: - Physical textures,

Collettea, Francette Thominettea, Sylvie Escribanob, Angèle Ravacholb, Arnaud Morinb, Gérard Gebelc,∗ aLaboratoire d’Ingénierie des Matériaux, ENSAM, 151 Boulevard de l’Hôpital, 75013

Optical transmittance spectra versus wavelength in the visible region of GLAD titanium thin films deposited on glass substrates with an incidence angle a = 85° and after the annealing