Science Arts & Métiers (SAM)

The optimisation is performed with NSGA-II algorithm which may choose technical parameters blade length, transmission ratio or electro-mechanical coefficient in this example to maximise

Manual assembly line developed at the Arts et Métiers Campus in Lille, with educational and industrial transfer objectives Taking up various concepts detailed in this chapter,

In this paper, the term “EP” would imply the illusion of presence experience the sense of pres- ence, while the term “presence” would be reserved for experience of presence in its

The analytic tool pre- sented in this study utilizes an in-process sensing technol- ogy combined with HSC recordings, which allows a syn- chronized analysis of the HSC recordings with

Based on this concept, an assembly simulation approach integrating point-based Skin Model Shapes, along with mathematical constrained optimization and difference surface definition, are

This can be explained by the fact that the sputtering rate of Al is higher than the Mo one.[10]Finally, as observed in the case of the Cr,AlN coatings and for the same reason, we

Thus, this harmonic, if exploited, can increase significantly the torque density of the machine[5].The main drawback of such configuration is the magnetomotive force MMF spectrum which

Relation between gloss and the roughness parameter It was shown in this investigation that, whatever the mor- phological texture of the polymer coating,: a the average curvature radius