Science Arts & Métiers (SAM)

2 aExprimental setup,bShear and compression specimens In order to determine the mechanical behavior of the Ti17 alloy under extreme conditions, both compression and shear tests have

Results and discussion Figure 1: Ranking of the situations based on peak values of right and left handrim total force during propulsion Results based on total force are presented on

Keywords: Inspirational process, Case study, Conjoint Trends Analysis, CTA method 1 INTRODUCTION This paper describes a research project to model the cognitive processes of designers

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

To conclude, ATBC increases efficiently the elongation at break of PLA while maintaining the permeability coefficient of helium and keeping the barrier properties against oxygen and

For all of these reasons, a Q4P1 shape function based on global DIC approach has been chosen for the present study, concerning the displacement field measurement during orthogonal

Discussion 199 Chemical characterizations of a GO electrical steel after oxidizing and nitriding show that the kinetics 200 of nitrogen adsorption and diffusion highly depends on

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as