• Nenhum resultado encontrado

[PDF] Top 20 Corrosion resistance of Ni-Cr alloys in different mouthwashes

Has 10000 "Corrosion resistance of Ni-Cr alloys in different mouthwashes" found on our website. Below are the top 20 most common "Corrosion resistance of Ni-Cr alloys in different mouthwashes".

Corrosion resistance of Ni-Cr alloys in different mouthwashes

Corrosion resistance of Ni-Cr alloys in different mouthwashes

... odontológicas, Ni-Cr e Ni-Cr-Ti em três tipos de colutórios bucais com diferentes ingredientes ativos: colutório I – ...liga Ni-Cr foi menos reativa na presença de digluconato de ... See full document

4

Evaluation of Corrosion Resistance of Commercial Aluminum Alloys in Ethanol Solutions

Evaluation of Corrosion Resistance of Commercial Aluminum Alloys in Ethanol Solutions

... composition of which is described in Table 2. Potentiodynamic measurements in the different media were carried out using a three-electrode electrochemical cell and a Gamry Reference 600 ... See full document

12

Effect of some mouthwashes on the corrosion and tribocorrosion behavior of a Co-Cr dental casting alloy

Effect of some mouthwashes on the corrosion and tribocorrosion behavior of a Co-Cr dental casting alloy

... increase of Co content may increase the ...limit of solubility of chromium in cobalt; additional chromium would produce a highly brittle second ...added in order to refine the grain ... See full document

91

Mat. Res.  vol.16 número6

Mat. Res. vol.16 número6

... curves of the as-cast alloy in ...density of the alloy shows a slight variation with potential, which indicates the formation of a passive ...values of current density in passive ... See full document

5

Braz. Dent. J.  vol.23 número2

Braz. Dent. J. vol.23 número2

... formation of a protective passive layer ...the corrosion resistance of a dental alloy. The quantity of released metal changes markedly depending on the nature and strength of the ... See full document

8

Cr-Ni ALLOY ELECTRODEPOSITION AND COMPARISON WITH CONVENTIONAL PURE Cr COATING TECHNIQUE

Cr-Ni ALLOY ELECTRODEPOSITION AND COMPARISON WITH CONVENTIONAL PURE Cr COATING TECHNIQUE

... hexavalent Cr ion baths has many disadvantages, such as a low cathode current efficiency, high operating temperature and being harmful to human health and the ...conventional Cr coating from toxic ... See full document

9

Mat. Res.  vol.17 número6

Mat. Res. vol.17 número6

... The corrosion behavior at different positions (top and bottom) of the weld nugget zone along the thickness plates in AA6061-T6 aluminum alloys welded by friction stir lap welding, under ... See full document

12

Braz. Dent. J.  vol.17 número1

Braz. Dent. J. vol.17 número1

... characteristics of three commercially available porcelains fused to three Ni-Cr alloys and one experimental Co-Cr-Ti alloy, using a modified rectangular parallel shear test (20), which ... See full document

5

Mat. Res.  vol.15 número1

Mat. Res. vol.15 número1

... instead of crystallization from metallic glasses or complicated forming processes at high ...tips of the wedge-shaped ingots, the minimum diameter of nano-QCs approach to 4~6 ...size of ... See full document

6

Braz. Dent. J.  vol.16 número3

Braz. Dent. J. vol.16 número3

... findings of this study showed that the Viron alloy had the best performance, followed by Verabond and ...are in agreement with those of other reports that observed the existence of significant ... See full document

5

Mat. Res.  vol.7 número1

Mat. Res. vol.7 número1

... vacancies in spinel ...optimization of non-stoichiometric wustite and magnetite. Work on the updating of the sulfide phases in the Fe-Cr-Ni-Co-S system is in ...equilibria ... See full document

12

Mat. Res.  vol.2 número4

Mat. Res. vol.2 número4

... fraction of 50% ferrite and 50% austenite, conciliate high corrosion resistance with good mechanical ...But, in many circumstances different phase transformations may occur, such as ... See full document

9

Soldag. insp.  vol.21 número3

Soldag. insp. vol.21 número3

... wear resistance behavior of different high Cr and Nb alloyed hardfacing deposits carried out by Self-shielded Flux Cored Arc Welding, considering the resulting microstructures as base for the ... See full document

12

Improvement of corrosion resistance in NaOH solution and glass forming ability of as-cast Mg-based bulk metallic glasses by microalloying

Improvement of corrosion resistance in NaOH solution and glass forming ability of as-cast Mg-based bulk metallic glasses by microalloying

... enthalpy in the alloy system. The increase of the GFA by the partial replacement of Mg by Ag in Mg- Ni-based alloys may be explained by the large difference in atomic size ... See full document

4

Resistance to Pitting Corrosion in Steels Based on the Fe-Cr-Ni-C System

Resistance to Pitting Corrosion in Steels Based on the Fe-Cr-Ni-C System

... performed in triplicate for each condition. An aerated solution of synthetic marine medium with a concentration of 60,000 ppm at room temperature Cl, prepared according to ASTM D1141-98, was ... See full document

5

CORROSION RESISTANCE OF WATER-THINNABLE PAINT SYSTEMS

CORROSION RESISTANCE OF WATER-THINNABLE PAINT SYSTEMS

... spraying in two, three or four layers, the break between the individual layer applications was at least 24 hours; the environment temperature was 22 ...°C. In order to achieve a good drying of the ... See full document

8

Matéria (Rio J.)  vol.20 número2

Matéria (Rio J.) vol.20 número2

... results of infrared was possible to determine the presence of the SAM molecules on the aluminum surface, because characteristic bands were ...character of the SAM solution towards the aluminum alloy ... See full document

16

Mechanical behavior and corrosion properties of some AA6XXX aluminum alloys in T5 temper

Mechanical behavior and corrosion properties of some AA6XXX aluminum alloys in T5 temper

... [r] ... See full document

5

THE APPLICATION OF Ni FOR IMPROVEMENT OF Al-Si-Fe ALLOYS

THE APPLICATION OF Ni FOR IMPROVEMENT OF Al-Si-Fe ALLOYS

... effect of iron can be eliminated by addition of suitable corrector, whose compounds with aluminium, silicium and iron segregate in less harmful shape (skeleton shaped particles or „Chinese script“) ... See full document

4

Caracterização Microestrutural e Tribocorrosiva de Sistemas Metalocerâmicos Odontológicos do Tipo Ni-Cr/Porcelana E Ni-Cr/Ti/Porcelana

Caracterização Microestrutural e Tribocorrosiva de Sistemas Metalocerâmicos Odontológicos do Tipo Ni-Cr/Porcelana E Ni-Cr/Ti/Porcelana

... function of partial or total compromised teeth, having to remain permanently joined to remainder ...with Ni-Cr metallic systems (metal-ceramic system) allows that the metallic substructure ... See full document

114

Show all 10000 documents...