[PDF] Top 20 Effect of chlorhexidine on the bond strength of a selfetch adhesive system to sound and demineralized dentin

... evaluated the effect of a 2% chlorhexidine-based disinfectant (CHX) on the short-term resin-dentin bond strength of a self-etch adhesive ... See full document

... setting the composite in a layering technique and using ...Objective: The aim of this in vitro study was to verify the effect of resin-modiied glass-ionomer cement ... See full document

... Objective: To evaluate the influence of caries-affected dentin on bond strength of a universal one-step and a multi-step etch-and-rinse ... See full document

... Introduction: The increase of the adhesive infiltration in the dentin may reduce the gaps in bond ...interface. The sodium hypochlorite (NaOCl) has been ... See full document

... (Fig.1). The smear layer was thicker when the preparation was done with the coarse diamond bur, producing a more irregular surface with groves compared to the remaining ...(15). ... See full document

... decrease of bond strength in dentin treated with sodium hypochlorite ...(NaOCl). The aim of this study was to evaluate the effect of non-thermal argon ... See full document

... Introduction: The self-adhesive resin cements have been introduced to the market in order to reduce the clinical steps and, thus, reducing the operative time ... See full document

... Purpose: To evaluate the effect of the use of ...0.5% and 2% chlorhexidine digluconate on the immediate bond strength of a ... See full document

... Abstract: The purpose of this study was to investigate the effect of CPP-ACP treatment and Nd:YAG laser on microtensile bond strength (µTBS) of ... See full document

... that the curing unit distance would not influence the quality of hybridization of self- etching adhesives was partially accepted, since the distance did not affect the leakage ... See full document

... made to carry out the modification of water glass with zinc ...nanoxide. The aim of the research was to determine what effect the modifier added to ... See full document

... disc system, designed to evaluate the tribological properties of materials used for parts of machinery and equipment constituting the friction ...possible to ... See full document

... Abstract: The aim of this in vitro study was to compare the degrada- tion of resin-dentin bonds of an etch-and-rinse adhesive system to pri- ... See full document

... development of steel grades for responsible engineering castings consists mainly in systematic increase of the imposed ...is the reason why the low-alloy structural steels of ... See full document

... calculus and soft- tissue deposits with a hand scaler, and then by ap- plying a rubber cup and ine pumice water ...slurry. The teeth were stored in the 3 solutions most com- monly used ... See full document

... order to obtain specimens for the microtensile test, blocks (4 mm in height) of self-polymerizing resin composite (Concise Orthodontics, 3M ESPE, ...built-up on the ceramic surfaces ... See full document

... which the conventional adhesive system Ambar and resin cement All Cem were used, exhibited the highest bond strength mean with statistical difference in comparison with ... See full document

... min of isothermal annealing the β phase formed grains with boundaries which are the most ...With the general trend of size reduction grain β phase, with increasing time τ_ia, increase ... See full document

... exclusively to CHX. Recently, De Munck et al. (15,20) found enzymatic bond degradation to be minimized by the use of mild ...released and activated MMPs are active for only a few ... See full document

... made of X38CrMoV5-1 steel. In the body of the chill were installed symmetrically 3 sections of cooling ...nozzles. The nozzles were placed in such a way that each section ... See full document