[PDF] Top 20 Effect of surface pretreatments on the microtensile bond strength of lithiumdisilicate ceramic repaired with composite resin

... dried with a stream of warm air (45 ± 5 °C) generated from a blow dryer (model RV456ABG; Revlon, El Paso, TX, USA) for 15 s to approximately 15 cm from the ...surface. The air ... See full document

... evaluated the effect of flowable composite resin application on the microtensile bond strength (µTBS) of adhesive systems to ...surfaces ... See full document

... evaluated the effect of air drying temperature and different silane coupling agents on the bond strength between glass fiber posts and composite resin ... See full document

... Half of the specimens from each block were immediately tested for microtensile bond strength (µTBS), while the other half was subjected to storage for 6 months, thermocycling ... See full document

... purpose of this study was to evaluate the microtensile bond strength of a repair composite resin to a leucite-reinforced feldspathic ceramic (Omega 900, ... See full document

... proving the bond strength between artiicial teeth and denture base, as coating the tooth with monomer or other chemical agent, before packing the resin ...(11,18). ... See full document

... evaluated the effect of matrix metalloproteinase (MMP) inhibitors - 2% (CHX) and sodium fluoride (NaF) (5000 ppm) - on microtensile bond strength (μTBS) of ... See full document

... One of the faces of each ceramic block, with dimensions of 5x6mm, was planed out with water sandpapers with granulation of 300, 600, 800, 1000, 1200 to ... See full document

... Abstract: The effects of several ceramic surface treatments on bond strength of a polymer-infiltrated ceramic network and resin composite as ... See full document

... Bond strength of the composites did not differ whether immediately after or three months after ...because the time interval was insufficient to reduce the strength ... See full document

... of the dentin surface with phosphoric acid removes the smear layer and the smear plugs, increasing tubule diameter and dentin ...Rinsing with water probably results in ... See full document

... casting of high- duty parts for automotive applications. A wide range of these alloys has been specified by Western ...was the aim of the authors of this study to “enrich” ... See full document

... materials with unique properties intermediate between the properties of metals and ...high strength and resistance to oxidation, combined with sufficient ductility and fracture ... See full document

... and resin cement), cohesive (within the resin cement) or combination (areas of ad- hesive and cohesive ...classification, the adhesive area was divided into quadrants, and in each ... See full document

... effect of mechanical cycling on the bond strength be- tween metallic posts and resin cement and between ceramic posts and resin ...a ceramic post was ... See full document

... elements of the aircraft engines (so called „Flight safety parts” - ...subject of exceptional requirements in the production and control ...lot of requirements of the ... See full document

... analyzes the inluence of the frequency of pulses and energy density on the capacity of Er:YAG laser to remove the substrate that is being irradiated, one observes ... See full document

... evaluated the effect of antioxidant agents on microtensile bond strengths (µTBS) of composite to bleached ...chloride. The groups were bleached with ... See full document

... for the impact of pressure drop on the human body has been investigated in the present ...studies. The studies has been aimed at personnel (army and mountaineer) who would be ... See full document

... sufficient bond strength are among the prerequisites for intraoral application of bonded PEEK ...along with the use of epoxy adhesives are commonly used to bond ... See full document