• Nenhum resultado encontrado

Reengineering of Permanent Mould Casting with Lean Manufacturing Methods

N/A
N/A
Protected

Academic year: 2017

Share "Reengineering of Permanent Mould Casting with Lean Manufacturing Methods"

Copied!
8
0
0

Texto

Loading

Imagem

Fig. 1. Low pressure casting station   of car wheels castings [2]
Fig. 4. Temperature range of cast and die in cooling process with 0.65 MPa pressure air and with water mist 0,45/0,50 MPa [2]
Fig. 5. Reorganization of casting machines into production cells
Fig. 6. Reduction of changeover time with SMED method [7]
+3

Referências

Documentos relacionados

Because of the way of automatic transmission functioning it is possible to diagnose Honda Civic 4d by acceleration in the mode S, but not in the manual mode.. Key words : Honda

O gráfico de barras que é apresentado no fim do tempo de resposta atribuído a cada questão, indicando quantos alunos (ou grupos) responderam a cada opção, permite ao professor

The scope of this contribution was to improve the water resistance and water barrier properties of starch films obtained by gel casting with the incorporation of nanoclay,

(Apocynaceae) seeds from two ecosystems of northeastern Brazil (Caatinga and Restinga) and subjected to water stress in light and darkness at 30°C after 35 days.. Greek, capital

This study and a recent synthesis (GEIST & LAMBIN, 2001) question this general assumption. It has been observed that as households age and children leave to form new

Thus, reaction layer and castability of titanium casting using an experimental spinel-based investment (VR) with short heating cycle were compared with the

The structure of the remelting zone of the steel C90 steel be- fore conventional tempering consitute cells, dendritic cells, sur- rounded with the cementite, inside of

Now there is still one label left in the residual list of v 1 to complete the labeling.. There are at least one label left in the residual list of v 2 and two labels left in that of