Science Arts & Métiers (SAM)

Ahmadi Institute of Mechanical Engineering I2M, TREFLE department, Arts et Métiers ParisTech - Talence, 33400 Key words: porous media, numerical simulation, inertial effects,

The GranOO workbench, a new tool for developing discrete element simulations, and its application to tribological problems Damien Andréa,⇑, Jean-luc Charlesa, Ivan Iordanoffa, Jérôme

Keywords: Inspirational process, Case study, Conjoint Trends Analysis, CTA method 1 INTRODUCTION This paper describes a research project to model the cognitive processes of designers

This can be explained by the fact that the sputtering rate of Al is higher than the Mo one.[10]Finally, as observed in the case of the Cr,AlN coatings and for the same reason, we

DIRECT NUMERICAL SIMULATION OF HYPERSONIC BOUNDARY LAYERS IN CHEMICAL NON-EQUILIBRIUM Donatella Passiatore∗1,2, Luca Sciacovelli2, Giuseppe Pascazio1, and Paola Cinnella2 1 DMMM,

 Focus on Life Cycle Assessment • USEtox model • Limitations • Case studies  Impact of nano-particules  Impact of Chromium • Conclusion April 2018 III International

In the case of an impact on an incompressible liquid, the peak pressure is proportional toρ V0 c2, withVcthe expansion velocity of the surface contact, see Cointe and Armand, 1987;Zhao

Numerical and experimental investigations of Ti-6Al-4V chip generation and thermo-mechanical couplings in orthogonal cutting Mahmoud Harzallaha,∗ , Thomas Pottiera, Johanna Senatorea,