Flexural strength
An experimental study on flexural strength enhancement of concrete by means of small steel fibers
... concrete strength, effect of fiber distribution on flexural strength of ultra-high strength concrete has been ...ultimate flexural strength and time to first crack have been ...
9
State of art an Overview on the Tensile Strength and Flexural Strength of Concrete in different Curing Methods
... the strength of concrete” by Ajay Goel ...average flexural strength of concrete at 3 days in plastic film is ...the flexural strength of concrete at 3 days in water curing is ...tensile ...
4
Surface agents' influence on the flexural strength of bilaminated ceramics
... the flexural strength of a ceramic ...the strength values (σ, MPa) and the failure modes were ...the flexural strength of the bilaminated ceramic ...
7
Effect of incorporation of 2-tert-butylaminoethyl methacrylate on flexural strength of a denture base acrylic resin
... on flexural strength after incorporation of ...ratios. Flexural strength of the specimens was tested and results were analyzed by ANOVA and Tukey’s test ...for flexural strength ...
5
Assessment of the flexural strength of two heat-curing acrylic resins for artificial eyes
... the flexural strength for acrylic resins, either con- ventionally activated by heat or microwave-cured, must not be below 65 ...flexure strength values found (Table 1) are above this value, ...
5
Effect of a post-polymerization treatments on the flexural strength and vickers hardness of reline and acrylic denture base resins
... irradiation. Flexural strength tests were performed at a crosshead speed of 5 mm/min using a three-point bending device with a span of 50 ...The flexural strengths values were calculated in ...higher ...
6
Effect of carbamide peroxide bleaching gel on composite resin flexural strength and microhardness
... Considering the increasing use of aesthetic restorative materials on posterior teeth, as well as the dental bleaching procedures, it is important to evaluate the effect of bleaching agents on the mechanical properties of ...
4
A castor oil-containing dental luting agent: effects of cyclic loading and storage time on flexural strength
... A cast or oil- cont aining dent al lut ing agent wit h a 10% weight percent age ( wt % ) of calcium carbonat e r esist ed m echanical cycling w it hout decr eases in.. ÀH[XUDO VW[r] ...
6
Mat. Res. vol.14 número3
... study, flexural strength together with pore structure, thermal behavior and microstructure of concrete containing ground granulated blast furnace slag with different amount of ZnO 2 nanoparticles has been ...
8
Braz. Dent. J. vol.27 número5
... fracture of the zirconia/porcelain set. They attributed the low resistance of the conventional porcelain to technical failures and structural weakness caused by internal porosities and the higher resistance of pressed ...
8
Braz. Dent. J. vol.21 número6
... mean flexural strength (8%) than low-speed straight handpiece at 22,000 ...the flexural strengths were variable, ranging from ...lowest flexural strength value recorded ...
5
Effect of microwave disinfection on physical and mechanical properties of acrylic resins
... impact strength and flexural strength of the evaluated acrylic resins was partly ...Impact strength values of the resins comparatively and within each material did not differ significantly in ...
6
Effects of extreme cooling methods on mechanical properties and shear bond strength of bilayered porcelain/3Y-TZP specimens
... Three-point flexural strength tests (FS) were performed on specimens with porcelain under tension (PT, n = 30) and zirconia under tension (ZT, n = ...bond strength tests (SBS, n = 15) were performed ...
7
Mat. Res. vol.7 número3
... The flexural strength was measured by the four-point bend- ing method, hardness was determined by the Vickers’s in- dentation method and fracture toughness by the Indenta- tion Strength in Bending ...
7
J. Appl. Oral Sci. vol.13 número4
... compressive strength values were found for the continuous, exponential, intermittent and stepped light methods, whereas PAC and LED obtained the lowest ...only. Flexural strength results were not ...
6
Strength Evaluation of Steel-Nylon Hybrid Fibre Reinforced Concrete
... flexural strength is observed by 20.31 % for mix MS75N25 with respect to reference mix. It is also seen that the addition of nylon fibres increase the flexural strength. The modulus of rupture ...
5
Bacterial viability and physical properties of antibacterially modified experimental dental resin composites.
... (flexural strength, modulus, water sorption, solubility, surface roughness, polymerization shrinkage, contact angle, surface free energy) of four antibacterially modified experimental dental resin ...
11
Chromatic reintegration of historical mortars with lime-based pozzolanic consolidant products
... for flexural strength, and MR5 consolidants reached lower values in both flexural and compressive strength, compared to MK ...on flexural and compressive ...
9
The influence of brick residues in the behaviour of lime mortars
... This experimental work’s intention is to analyze lime based mortars behaviour, with brick residues in its composition. The studied mixtures have brick dust as pozzolan that develops a reaction with calcium hydroxide ...
10
Microcrystalline cellulose and sisal fibre reinforced cementitious composites
... The main objective of this research work was to study the behaviour of cementitious composites reinforced at multiscale with MCC and sisal fibres. In order to do so, cementitious composites were prepared with several ...
85