• Nenhum resultado encontrado

[PDF] Top 20 Internal curing in cement-based materials

Has 10000 "Internal curing in cement-based materials" found on our website. Below are the top 20 most common "Internal curing in cement-based materials".

Internal curing in cement-based materials

Internal curing in cement-based materials

... approach in the practice is associated with controlling the chemical reactions occurring in the system which is subjected to environmental ...found in the literature, referring to the work by Hori et ... See full document

175

EFFECTS OF BLAST-FURNACE SLAG ON NATURAL POZZOLAN-BASED GEOPOLYMER CEMENT

EFFECTS OF BLAST-FURNACE SLAG ON NATURAL POZZOLAN-BASED GEOPOLYMER CEMENT

... Portland cement and shows the least efflorescence. As seen in Figure 1 and discussed earlier, the pumice- type natural pozzolan used in this work contains a number of crystalline phases including ... See full document

11

RICE HUSK DERIVED WASTE MATERIALS AS PARTIAL CEMENT REPLACEMENT IN LIGHTWEIGHT CONCRETE

RICE HUSK DERIVED WASTE MATERIALS AS PARTIAL CEMENT REPLACEMENT IN LIGHTWEIGHT CONCRETE

... waste materials, rice husk ash and broiler bed ash, was considered as partial replacement for Portland ...Portland cement (CEM I, class 42.5R), a second type with 10% cement replacement with rice ... See full document

11

Formaldehyde emission in wood based panels: Effect of curing reactions

Formaldehyde emission in wood based panels: Effect of curing reactions

... found in the literature about alternative catalytic systems for UF ...tried in the past, but the results obtained were not adopted by industry due to the low reactivity of the glue mix when compared to the ... See full document

11

Mechanical properties of microsphere based composite materials

Mechanical properties of microsphere based composite materials

... increase in the sintering time and with decrease in the diameter of the spheres ...reduction in the pore size; atomic diffusion into the pore results in reduced size of the ...concentration ... See full document

59

SrVO3-based anode materials for hydrocarbonfueledsolid oxide fuel cells

SrVO3-based anode materials for hydrocarbonfueledsolid oxide fuel cells

... drop in ionic conductivity at intermediate temperatures ...+3 in reducing atmospheres [Yahiro, 1989], causing onset of electronic conductivity with impact on open cell voltage and internal short ... See full document

185

Comparison of Strength for Concrete with GGBS and Cement Using Accelerated Curing Method

Comparison of Strength for Concrete with GGBS and Cement Using Accelerated Curing Method

... growth in population, urbanization and advanced technologies of construction, there is a vast consumption of energy and resources in the production of ...concrete. In the earlier times, the main ... See full document

5

Thermal properties of cement-based composites.

Thermal properties of cement-based composites.

... envelope materials and under or overestimate the dimensioning of heating and air- conditioning systems (Kośny & Kossecka, ...incur in higher (or lower) energy consumption in the future, besides ... See full document

118

Self-Powered Sensors based on Triboelectric Materials

Self-Powered Sensors based on Triboelectric Materials

... IBD. In the first, the metal tape presents a smaller resistance, much in part because the tape is thicker than the deposited ...TENG. In the second, we can avoid the glue, however, adhesion is only ... See full document

84

Effects of cement-curing mode and light-curing unit on the bond durability of ceramic cemented to dentin

Effects of cement-curing mode and light-curing unit on the bond durability of ceramic cemented to dentin

... 10) based on the fac- tors “light-curing units” (QTH and LED) and “resin cement” (Variolink II photo- and dual- cured, Ivoclar Vivadent, Schaan, Liechtenstein; Base, G24884; Catalyst, ...The ... See full document

7

Cellular differentiation, bioactive and mechanicalproperties of experimental light-curing pulpprotection materials

Cellular differentiation, bioactive and mechanicalproperties of experimental light-curing pulpprotection materials

... observed in these experimental resins in terms of pH, kinetics of precipitation and morphology of the apatite may have influ- enced the biocompatibility and played a role in the cell ... See full document

11

Investigation of cement based composites made with recycled rubber aggregate

Investigation of cement based composites made with recycled rubber aggregate

... nent materials for all mortar series are shown in Table ...of cement based composites was per- formed using the laboratory mixer RILEM-CEM, in the following steps: first, water and ... See full document

9

Improving the Radiopacity of Calcium Aluminate Cement Based Blends

Improving the Radiopacity of Calcium Aluminate Cement Based Blends

... properties in agreement with the specific function of the implant. Thus, in this study, some compositions were also evaluated under uniaxial cold crushing strength after 7 days of curing in ... See full document

11

Obtention of eco-efficient cement-based composites using industrial waste.

Obtention of eco-efficient cement-based composites using industrial waste.

... and in blended pastes and ...Blended cement pastes presented good flowability, compatibility with PCE-based superplasticizers, no adverse effects in the hydration kinetics and acceptable ... See full document

230

Microindentation of Polymethyl Methacrylate (PMMA) Based Bone Cement

Microindentation of Polymethyl Methacrylate (PMMA) Based Bone Cement

... polymeric materials also used as matrix for carbon fibers composites ...applications in medicine, since they, when used as a reinforcing material significantly enhance the mechanical properties of the ... See full document

7

USE OF CRUMB RUBBER TO IMPROVE THERMAL EFFICIENCY OF CEMENT-BASED MATERIALS

USE OF CRUMB RUBBER TO IMPROVE THERMAL EFFICIENCY OF CEMENT-BASED MATERIALS

... fires. In addition, cleanup of tire fire aftermaths is quite expensive and the water used to put out the fires usually becomes a way to carry oil from burning ...them in different applications such as: Use ... See full document

11

Effect of light-curing method and indirect veneering materials on the Knoop hardness of a resin cement

Effect of light-curing method and indirect veneering materials on the Knoop hardness of a resin cement

... grown in the last few years due to an increased application of esthetic indirect restorative materials such as ceramics and resin ...result in higher fatigue compressive strength of all-ceramic ... See full document

5

Biodiesel by-product as an admixture for cement-based materials : an experimental study

Biodiesel by-product as an admixture for cement-based materials : an experimental study

... calcareous materials to be used as cements in mortars were gypsum and ...non-hydraulic materials have been used in Egypt (~3000 B.C.) and even earlier in Crete, Cyprus, Greece and ... See full document

128

Uma minirevisão sobre a incorporação de nanotubos de carbono em materiais a base de cimento / A minireview of carbon nanotubes incorporation in cement-based materials

Uma minirevisão sobre a incorporação de nanotubos de carbono em materiais a base de cimento / A minireview of carbon nanotubes incorporation in cement-based materials

... Assim, este artigo apresenta uma visão geral de algumas das pesquisas publicadas sobre o uso dos CNTs como adição em misturas a base de cimento e seus efeitos nas propri[r] ... See full document

10

Chromium speciation in cement and cement-related materials from Brazil.

Chromium speciation in cement and cement-related materials from Brazil.

... SPECIATION IN CEMENT AND CEMENT-RELATED MATERIALS FROM ...Cr(VI) in cement and cement-related materials was ...spectrophotometry based on ... See full document

4

Show all 10000 documents...