• Nenhum resultado encontrado

Lat. Am. j. solids struct. vol.13 número11

N/A
N/A
Protected

Academic year: 2018

Share "Lat. Am. j. solids struct. vol.13 número11"

Copied!
1
0
0

Texto

(1)

1996

Latin American Journal of Solids and Structures 13 (2016) 1996

ANNOUNCEMENT

The International Society of Impact Engineering (www.impacteng.org) was founded during the 1st. International Conference of Impact Loading of Structures and Materials, ICILSM, in Turin, 22–26 May 2016. It aims to congregate researchers who share enthusiasm for the Impact Engineering, to promote and supervise the ICILSM Conferences, to be a repository of theses/reports, among others.

The Society is organized as follows:

Administrative Board

Marcílio Alves, President

Magnus Langseth, Vice-President Genevieve Langdon, Secretary Dong Ruan, Vice-Secretary

Board Members

Giovanni Belingardi Tore Borvik

Vikram Deshpande Stefan Hiermeier Timothy J. Holmquist Dora Karagiozova Qingming Li Guoxing Lu Eric Markiewicz Michael Worswick

Five Honorary Members, seen as personalities that have been contributing significantly to the development of Impact Engineering activities, were nominated: Prof. Norman Jones, Prof. Tomasz Wierzbicki, Prof. Narinder Gupta, Prof. Gerald Nurick and Prof. Tongxi Yu.

We urge researchers and engineers to register as a member of the International Society of Im-pact Engineering in www.imIm-pacteng.org.

We are all very keen to promote the Society and we hope to gain full support from the commu-nity.

Marcílio Alves

President, on Behalf of the Administrative Board and Board Members

International Society of Impact Engineering | www.impacteng.org

Referências

Documentos relacionados

Based on the tensor analysis and using an orthogonal curvilinear coordinate system, a complete set of linear partial differential equations for piezo-magneto-elastic behavior

The prime objective of the present work to analyse free vibration behaviour of the flat/curved panel of different geometries (flat, cylindrical, spherical, hyperbolic and

Hence, it can be concluded that Gamma and Birnbaum-Saunders distributions are the best probability models for the crack shape factor ( Y c ) and geometric factor ( Y g ) in

Finite element analysis was used to investigate the impact behavior of the foam-cored sandwich shells under the ballistic impact. The ballistic limit, failure mode

Results obtained for static and free vibration analyses are compared with those from higher order ESL theories and LW mixed and displacement based finite element

In order to reduce the structural vibrations of a mechanical system used in aerospace, a new sketch of eddy current damper (ECD), consisting of one cylindrical permanent magnet,

In this work, chip removal (coping saw, metal slitting saw, cubic boron nitride (CBN) disk, scoring, diamond disk, and laser cutting) and non-chip removal (razor blade tapping

Table 2 shows the frequency analysis in free vibrations of a three stepped cylindrical shell with different axial lengths and SD-SD ended supports obtained by using VWM and the