Heated Permeable Stretching Surface in a Porous Medium Using Nanofluids
Texto
Imagem
Documentos relacionados
using initial parameter values (i.e. a priori cost) and optimal parameter values obtained from the assimilation of satellite-derived size-fractionated chlorophyll and POC data at
The efficiency comparison criteria among the three methods of the (1 )100% confidence intervals (Exact, Asymptotic and TestSTAT confidence intervals) are the
In this analysis, it is observed that thermal conductivity parameter affects the transient velocity and temperature field of free convection flow the fluid near a semi
In the last six decades, the parameter z is used widely in TM researches. The parameter z is considered as the most important characteristic of TM and is called “Thermoelectric
This parameter was controlled using the ratio between ReO 2 and ReO 3 content and the illing factor parameter (ratio between mass and total inner volume of the quartz tube).
The lattice parameter, volume cell, X-ray density, grain size and % of crystallinity were determined using XRD data.. Grain size of the nanoparticles determined by
The ranking of each cutting parameter using the response table for signal to noise ratios (smaller is better) obtained for different parameter levels shows steam pressure as
7, a graph of load capacity versus slip parameter has been plotted for different values of the magnetic parameter, while the permeability and thermal parameters