• Nenhum resultado encontrado

J. Braz. Chem. Soc. vol.14 número4

N/A
N/A
Protected

Academic year: 2018

Share "J. Braz. Chem. Soc. vol.14 número4"

Copied!
1
0
0

Texto

(1)

J. Braz. Chem. Soc., Vol. 14, No. 4, 666, 2002.

Printed in Brazil - ©2003 Sociedade Brasileira de Química 0103 - 5053 $6.00+0.00

A

d

d

iti

o

ns

a

nd

C

o

r

r

e

c

ti

o

ns

Analytical Performance of an Inductively Coupled Plasma Optical Emission

Spectrometry with Dual View Configuration

Júlio C. J. Silva, Nivaldo Baccan and Joaquim A. Nóbrega 2003, vol. 14, No 2, 210-315.

In the Table 2 of the page 311, the correct values of IP and EP to Ba II (455.4 nm), Al I (308.2 nm), Ba II (233.5 nm), Mn II (260.6 nm), Mn II (257.6 nm), Mo II (203.8 nm), Mo II (202.0 nm) are 5.21 and 2.72 eV, 5.99 and 4.02 eV,

5.21 and 6.0, 7.44 and 4.75, 7.44 and 4.81, 7.1 and 6.08, 7.1 and 6.13, respectively.

Referências

Documentos relacionados

The presence of more than one cathodic or anodic current peaks in the voltammogram can be associated to modifications in the structure (modifying the electronic states of the

In parallel to these electronic effects, an increase of the unit cell volume may also lead to an increase of the hydrogen storage capacity due to a decrease of the hydrogen

Improvement in the stability and selectivity can be attributed to Prussian Blue/Rhodium modification since the amperometric signal due catalytic reduction of H 2 O 2 is lower

When the Fe (II) concentration (at a 10:1 ratio) increased, the cathodic peak shifted to a more negative potential than with other solution ratios and its current

These results suggest that the cathodic peak current i pc (II) results from the reduction of a product formed by the reaction between citrate and some product formed during DA

The present work is devoted to study the corrosion behavior of iron and AISI 304 stainless steel in neutral aqueous solutions of tungstate containing chloride ions, by using

So we tested the voltammetric method to assay the triazines with artificial HD and HS samples spiked with a ten-fold excess of the contaminants found in the dialysis water and also

The lower k value for the AZ91HP-alloy is one reason for its better corrosion resistance, compared to magnesium, since in the case of pitting, about 50% of the anodic current