Multidimensional optimization of perovskite-type solar cells
Texto
Documentos relacionados
While those authors, and all later previously cited studies, calculated the index with the objective of ascertaining the readiness of EU countries to join EMU by the end of the
Although these fabrication conditions yielded the best performing device during this work, it is believed that the use of Ethyl acetate as anti-solvent can further improve
show the plots for the absorbed power density through the cell volume for spe- cific wavelengths, indicated by the arrows. The leftmost graph is the absorbed power for 350 nm and
Figure 8 - SEM images of MAPbI 3 samples with different solvent mix ratios used and different toluene volumes added.. As observed in Figures 8 and 9 , when no toluene is
deposited over mesoporous layer with different amonts of chlorobenzene: 100 µL (black), 120 µL (red) and with chlorobenzene inside spin-coater (blue). 120µL of CuSCN was dropped and
the solar cells reflectance differs for wavelength value higher than 1000 nm, with the standard-thick solar cell with 2 µm CIGS having a poor reflectance. This is due to: i) the
Por outro lado, nesta fase da análise também não se detectou um perfil sócio- demográfico distintivo entre quem considera que seria necessário “a cidade ter mais
Assim, esse trabalho objetivou avaliar a qualidade microbiológica e físico-química e veri car a ocorrência de substâncias inibidoras do crescimento microbiano no leite cru