Science Arts & Métiers (SAM)

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

The novel kinetic model of AUN thermal aging was developed from a mechanistic scheme previously established for polyamide 11, by adding some extra paths of thermolytic alkyl radical

The different works dealing with the influence of aging on the ultimate properties which were achieved on rubber materials Ben Hassine et al., 2014; Colin et al., 2019; Nait Abdelaziz

Verdu, Hydrolysis of polyethylene terephtha- late: a kinetic study, Polym.. Goje, Auto-catalyzed hydrolytic depolymerization of polybutylene tereph- thalate waste at high temperature,

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

After describing the 3D angle-interlock composite studied in this work, in-plane tensile and shear tests conducted to determine the elastic modulus in both weft and warp directions and

The displacement represents the distance measured by DIC between two points located on the compression diagonal at 45◦to the rails passing through the centre of the shear area

Crack delamination appears at inclined drilling in the TBC at the BC/TBC interface at the leading edge but only from the second laser pulse when the laser beam interacts with the