Science Arts & Métiers (SAM)

Results and discussion Figure 1: Ranking of the situations based on peak values of right and left handrim total force during propulsion Results based on total force are presented on

2k 1A B1 D2L TEM = w L 3 where kw1 is the winding factor, AL A/m is the stator rms electric load, B1 T is the peak value of the fundamental of the magnets flux density at the stator

The tests have shown a reduction in the cutting force, and have highlighted the impact of laser assistance on the integrity surface roughness, appearance, residual stress and the tool

On the basis of these estimated models, three amplitude dependent damage indexes are built: one that monitors the shift of the resonance frequency of the structure, another the ratio of

The dependency of the deposition probability and the dimensionless surface coverage Γ/ΓRSA on the frequency of the pitches λ, the Péclet number Pe and the favorable area fraction θ, as

In addition, the tensile stresses applied on the shot-sleeve inner surface during the cooling phase combined with the erosion phenomenon caused by the molten brass fall in the second

The displacement represents the distance measured by DIC between two points located on the compression diagonal at 45◦to the rails passing through the centre of the shear area

The presence of this weakly varying flow structure, living on the edge of turbulence, suggests the existence of a relative cha- otic attractor embedded in the edge, like in the case of