Science Arts & Métiers (SAM)

& The slug temperature should be optimised in order to: allow the increase of the material desagglomeration and thus decreases the thixoforging load avoid the collapse of the slug

On the basis of these estimated models, three amplitude dependent damage indexes are built: one that monitors the shift of the resonance frequency of the structure, another the ratio of

Introduction Nomenclature CF: Carbon Fibers CFRP: Carbon Fibers Reinforced Plastics EOL: End-of-Life ILSS: InterLaminar Shear Strength LCA: Life Cycle Analysis rCF: Recycled Carbon

Hardness-load modelling To predict the hardness variation as a function of the applied load, or in the same way as a function of the indenter displacement, the application of the model

This article proposes to go further in the optimization of the product, by simultaneously characterizing the design, in terms of reliability and maintainability, as well as the dynamic

2 aExprimental setup,bShear and compression specimens In order to determine the mechanical behavior of the Ti17 alloy under extreme conditions, both compression and shear tests have

The proposed proce- dure AK-ILS takes advantage of several points of the literature review: •the Hammersley sequence for the initial design of experiments, •the Kriging metamodel

The presence of this weakly varying flow structure, living on the edge of turbulence, suggests the existence of a relative cha- otic attractor embedded in the edge, like in the case of