J. Braz. Soc. Mech. Sci. & Eng. vol.31 número1
Texto
Imagem
Documentos relacionados
The ranking of each cutting parameter using the response table for signal to noise ratios (smaller is better) obtained for different parameter levels shows steam pressure as
According to the results obtained, the influence of couple stresses enhances the squeeze film pressure, load carrying capacity, and decreases the response time as compared
Evolution of the time residuals with the variation of the nonlinear parameter updating considering strong nonlinearity, where RFS1 and RFS2 are the residuals by using Eqs.. The
The multibody dynamic model, which includes the main mechanical components of the hermetic compressor, is coupled with a finite elements model of the rotor and the
For the lower cutting speed (45 m/min), the dry machining always produced the smallest average burr heights and the MQL system with vegetable and mineral oils generally produced the
In addition, considering the accurate non- Newtonian character of most clay-water suspensions and the inherent uncertainty of rheometrical measurements, behavior transition
In particular, previous studies by Abé & Fujino (1994), Igusa & Xu (1994) and Jangid (1999), among others, have shown that multiple tuned mass damper (MTMDs) can be
47 Based on these considerations and on the thermodynamic data obtained, it is understandable that the adsorption of caffeine onto the surface of the carbon steel occurs