• Nenhum resultado encontrado

REM, Int. Eng. J. vol.70 número2

N/A
N/A
Protected

Academic year: 2018

Share "REM, Int. Eng. J. vol.70 número2"

Copied!
1
0
0

Texto

(1)

133

REM, Int. Eng. J., Ouro Preto, 70(2), apr. jun. | 2017 In 1880, upon creating the “Anaes da Escola de Minas” (School of Mines Annals), the Frenchman Henri Gorceix wrote in the irst preface: The creation of a periodical magazine that deals with the state of the mining industry in Brazil is a natural and necessary complement to the organization of the Ouro Preto School of Mines. As much one as the other have the goal of studying and making known the mineral riches of the country, as well as popularizing the means of taking advantage of them.

In 1936, REM was created and its preface said that the magazine was an attempt to achieve an academic dream, since its creators considered it to be a publication that would facilitate contact with the world.

J. Meadows, in his book “Communicating Research (Academic Press, 1998 – translated by Briquet de Lemos in 1999 with the title: “A Comunicação Cientíica”), wrote that: communication lies in the very heart of science. And it is as vital as research itself, since this research cannot be claimed to be legitimate until it has been analyzed and accepted by peers. This necessarily requires that it be communicated.

Meadows also wrote that: support for scientiic activities is costly and the inancial resources that are allocated to them will be wasted unless the research results are presented to the appropriate public. From whatever angle it is exam-ined, eficient and effective communication is an essential part of the scientiic investigative process.

It becomes of paramount importance to divulge the results. To the contrary, there will be “research trash”. Also important is how this disclosure is made. The lack of credibility of the publisher can jeopardize good research, which can kill the research efforts, as they become part of dead science.

Logically, scientiic merit, together with publisher credibility, punctuality, etc., are very important factors that can relect on the good disclosure of the research, but its peer evaluation is paramount. However, it is good to remember that some reviewers have yet to comprehend their importance and how much science owes them.

As such, the search for committed reviewers, the reduction of the analysis periods of an article, etc., are important to increase the “impact factor”, the image of the journal, and the emergence of new ideas and commitments in the dissemination of science.

Editorial

Editorial

Afiliada à

Geoscience

e-Journals

P U B L I S H I N G

Provider of EBSCOhost®

EBSCO

http://dx.doi.org/10.1590/0370-44672017700049

Prof. Jório Coelho

Editor-in-Chef

Doctor Engineer by Polytecnique Institute of Lorraine-France

Retired professor of Federal University of Ouro Preto - School of Mines-Department of Geology E-mail: editor@rem.com.br

Referências

Documentos relacionados

The yield strength, ultimate tensile strength, and percent elongation, determined from the curves obtained in the simulations, are compared to the values from the physical

Therefore, in this paper, considering the lack of practical procedures to set temperature ields in composite columns with steel tubes, we carried out an analysis of the

The use of multilayer closing systems, systems composed of two panels mediated by a layer of air and insulating material, can result in superior acoustical performance..

the joint resistance as the force at which the diametric deformation of the chord reaches 3% of the chord diameter. Lu’s deformation is computed as the relative

15220 (ABNT, 2003) because recycled material has lower thermal conductivity than natural aggregate; (c) It was neces- sary to paint the external wall with light colors to attend

This new Brazilian fall me- teorite is approved and listed as the 70th Brazilian meteorite by the Meteoritical Bulletin Database of The Meteoriti- cal Society, as well as

Evaluation of hydrogen-Induced cracking resistance of the In625 laser coating system on a C-Mn steel

Diameter standard deviation, pellet production and sphericity were identiied as the main effective input vari- ables that affect bed permeability during the drying stage