• Nenhum resultado encontrado

Artigo02 CAlmeida 2015 Table 4

N/A
N/A
Protected

Academic year: 2018

Share "Artigo02 CAlmeida 2015 Table 4"

Copied!
1
0
0

Texto

(1)

Table 4

Solvent

Sample

T

(ºC)

t

(h)

Cell/solvent

ratio

(% w/v)

Tm

(°C)

ΔHm

(J/g)

Tc

(°C)

ΔHc

(J/g)

Crystallinity

degree

(%)

Tdeg

(°C)

Chloroform S 4 36 1.5 171.65 94.55 50.83 19.75 65 278.92

Anisole

A2 120-130 0.25 6.0 172.38 88.70 58.53 25.95 61 279.05

A3 120-130 0.50 1.5 170.29 95.73 61.12 43.10 66 275.93

A4 120-130 0.50 6.0 171.55 89.32 61.05 39.39 61 264.39

A5 120-130 1.0 1.5 169.95 88.86 57.78 18.13 61 276.36

Phenetole

P2 120-130 0.25 6.0 170.19 87.89 55.63 9.04 60 277.19

P3 120-130 0.50 6.0 168.22 87.38 57.96 15.90 60 259.98

P4 120-130 1.0 1.5 167.87 88.97 55.62 31.96 61 245.92

Cyclohexanone

C4 120-130 0.50 1.5 170.31 90.03 62.47 33.80 62 273.27

C5 120-130 0.50 6.0 171.67 80.93 59.48 28.53 55 255.82

Imagem

Table 4  Solvent  Sample  T  (ºC)  t  (h)  Cell/solvent ratio  (% w/v)  Tm  (°C)  ΔHm (J/g)  Tc  (°C)  ΔHc  (J/g)  Crystallinity degree   (%)  Tdeg (°C)  Chloroform  S  4  36  1.5  171.65  94.55  50.83  19.75  65  278.92  Anisole  A2  120-130  0.25  6.0  1

Referências

Documentos relacionados

The tests of first count of germination (Figure 1c, Table 4), accelerated aging (Figure 1d, Table 4), and cold test for seeds from brown fruit (Figure 1e, Table 4) show reduction

The specific objectives were to determine the overall adherence rate for hypertension, diabetes and cholesterol medications; to evaluate differ- ences between primary and

The galvanic currents and the cell potentials of the galvanic couples between the two non – noble alloys and the Ni – based and the V-Gnathos ® Plus, were measured, as well as

[r]

e National Institute for Occupational Safety and Health (NIOSH) Recommended Exposure Limits (RELs) from the NIOSH Pocket Guide to Chemical Hazards ( http://www.cdc.gov/niosh/npg

[r]

Presenting an original methodology for measuring of working loads on the clamp dogs of rotating excavator working wheel carrying structure, enables to determine

To date, very little has been written about the influence of the substrate layer on the overall sensor impedance of single- and multilayer planar sensors (e.g., metal-oxide