Load Capacity
Effects of Couple Stress Lubricants on Pressure and Load Capacity of Infinitely Wide Exponentially Shaped Slider Bearing
... and load capacity of an infinitely wide exponentially shaped slider bearing lubricated with a non Newtonian couple stress fluid is ...and load are computed using continuous Galerkin finite element ...
6
The Carbon Nanotubes Effect into Single-lap Joint Failure Modes and Load Capacity: a Macromechanical Analysis
... tear (LFT) as a failure occurring within the substrate, close to the surface, characterized by tearing the surface layer of matrix, completely or partially exposing the reinforcement fibers. Figure 2 shows a diagram of a ...
10
Comissão 2.2 - Física do solo Least Limiting Water range and Load Bearing CapaCity oF soiL under types oF traCtor-traiLers For meChaniCaL harvesting oF green sugarCane
... a load capacity up to 10 Mg of sugarcane, being used two tractor-trailers coupled to the tractor with a total weight of the load of 46 Mg ...a capacity of up to 22 Mg of sugarcane, was a ...
8
Experimental Study on Fatigue Characteristics for Aluminium and Al-SiC Composite Material Edge Crack Specimens under Flexural Loading Conditions
... Low-cost, light weight aluminium matrix composites have a good potential for application to aerospace structures [1]. Aluminium is a very light metal with a specific weight of 2.7 g/cm 3 , about a third that of steel. ...
15
Rev. IBRACON Estrut. Mater. vol.9 número6
... of load capacity to use bending-axial load interac- tion ...safe load state and any point outside shows a com- bination of forces higher than the element’s load ...the load ...
14
Comput. Appl. Math. vol.26 número3
... Abstract. Lubricants with variable viscosity are assuming importance for their applications in polymer industry, thermal reactors and in biomechanics. With the bearing operations in machines being subjected to high ...
16
J. Braz. Soc. Mech. Sci. & Eng. vol.33 número3
... of load capacity versus slip parameter has been plotted for different values of the magnetic parameter, while the permeability and thermal parameters are taken as ...
6
Soil Stabilization with Lime for the Construction of Forest Roads
... Both the local soil and the soil-lime mixture responded well to the increase in compaction effort, with a reduction of W opt and an increase in γ dmax from the standard effort to the modified effort. Trindade et al. ...
8
DESIGN OF STRUCTURAL ELEMENTS IN THE EVENT OF THE PRE-SET RELIABILITY, REGULAR LOAD AND BEARING CAPACITY DISTRIBUTION
... bearing capacity produces a stronger effect on relative sizes of cross sections of a slab than the variability of ...bearing capacity distribution by pre-culling the construction ...
7
Steady State Thermo-Hydrodynamic Analysis of Two-Axial groove and Multilobe Hydrodynamic Bearings
... carrying capacity depends on the pressure developed inside the ...less load carrying ...its load carrying capacity decreases because of less pressure developed inside the ...ratio load ...
13
COMPACTION CAUSED BY MECHANIZED OPERATIONS IN A RED- YELLOW LATOSOL CULTIVATED WITH COFFEE OVER TIME
... and subject to the pressures of 25, 50, 100, 200, 400, 800 and 1,600 kPa. Each pressure was applied until 90% of the maximum deformation was reached, and then the pressure was increased to the next level (TAYLOR, 1948). ...
8
Lat. Am. j. solids struct. vol.11 número3
... the capacity, in terms of displacement ...theoretical capacity analysis of the main system of study evidenced some variations with respect to the experimental test, it was possible to identify that for ...
27
Static Limit Analysis of Reinforced Soil Structures by a Simple Finite Element and Second-Order Cone Programming
... collapse load for some well-known stability problems of soil mechanics, namely the bearing capacity of footings and the stability of slopes, are computed after the soil is ...
21
Osteotomia valgizante de tíbia com placa "calço" de Puddu: apresentação de técnica.
... Figure 5: Radiographic study, with load, pre and post , with load, pre and post , with load, pre and post , with load, pre and post , with load, pre and post-operatively -operatively -op[r] ...
6
DЕTERMINATION OF THE DRUM MILLS’ ENGINE CAPACITY BY USING NEURAL NETWORK WITH SUBORDINATE INPUT PARAMETERS
... the capacity of the engines of all kinds of drum mills and can be considered a reliable mathematical ...the capacity of the engine that operates a big industrious equipment is a responsible engineering ...
5
RGO, Rev. Gaúch. Odontol. vol.64 número4
... Based on the results of the present study, NaF 2% solution could be considered an effective method of disinfecting extracted human teeth, due to is capacity to reduce the microbial load of the microorganism ...
5
E CONOMICS, EXCLUSIVELY FOR ACADEMIC PURPOSES.T HIS REPORT WAS SUPERVISED BYR OSÁRIOA NDRÉ WHO REVIEWED THE
... The oil price is the hardest to predict input in the model. Nonetheless, Ryanair share price is not as dependent as one would expect on the oil price since the average airfares tend adjust to reflect the price of the ...
34
STRUCTURAL SAFETY IN WOODEN BEAMS UNDER THERMAL AND MECHANICAL LOADING CONDITIONS
... Wood is a renewable resource, recently attracting public attention, as an environmentally friendly material. This product is a building material with attractive attributes such as archi- tectural and structural ...
15
A Comparative Experimental Analysis of Tribological Properties Between Commercial Mineral Oil and Neat Castor Oil using Taguchi Method in Boundary Lubrication Regime
... Taguchi design of experiment technique enables us to model the experiments and analyse the influence of various parameters. In the present work, load and rpm have been considered as design parameters. The ...
12
TAAG: An Efficient Task Allocation Algorithm for Grid Environment
... Computational Grids are becoming more prevalent, due to the sharp decrease in the hardware and integration costs. Scientific applications in general, require higher computation capabilities. But affordability of a single ...
9