[PDF] Top 20 Experimental and numerical study of heat transfer in an endovenous laser treatment
Has 10000 "Experimental and numerical study of heat transfer in an endovenous laser treatment" found on our website. Below are the top 20 most common "Experimental and numerical study of heat transfer in an endovenous laser treatment".
Experimental and numerical study of heat transfer in an endovenous laser treatment
... The present work had the aim to investigate through experimental and numerical the heat transfer mechanisms evolved at the endovenous laser ablation (EVLA or EVLT) surgical procedure app[r] ... See full document
166
Modeling and numerical simulation of fluid flow and heat transfer of a steel continuous casting tundish
... Being an inherently component of the caster machine, the tundish has been designed to be not only an intermediate vessel between the ladle and the mold, but also a device to remove inclusions ... See full document
92
Study of heat transfer on front– and back-vented brake discs
... plays an important role in the automotive industry since it concerns directly with ...safety. In order to develop proper heat ventilation a wide range of brake discs have been ...types ... See full document
11
Experimental Investigation of Heat Transfer Effectiveness on Finned-Tube Thermoacoustic Heat Exchanger
... the heat transfer between two identical parallel-plate heat exchangers in an oscillating flow over a range of frequencies and gas displacement ...conducted in air ... See full document
6
Experimental and numerical study of I-shape slit dampers in connections
... flanges of the beam Figure 1 . Under seismic loading, the slit dampers transfer tension and compression forces of the beam flanges to the ...couple of forces develop bending moment ... See full document
17
Experimental Analysis Of Heat Transfer From Square Perforated Fins In Staggered Arrangement
... section of 15 mm x15 mm and are attached on the upper surface of the base plate as shown in Fig ...values of 0, 0.333 and 1, are perforated at the 17 mm from bottom tip of ... See full document
8
Numerical simulation of heat transfer and turbulent flow of water nanofluids copper oxide in rectangular microchannel with semi-attached rib
... ratio of pumping power in tooth microchannel compared to smooth microchannel in dif- ferent Reynolds and different solid nanoparticle volume ...fractions. In the above figures, with a ... See full document
25
Numerical analysis and parametric study of multilayered microchannel heat sinks
... rials of heat sink, coolant, flow direction, channel shape and size, velocity ratio between two channels, and so ...designs of the two-layered MCHS, researchers further constructed ... See full document
10
Heat transfer to Newtonian and non-Newtonian fluids in cross-corrugated chevron-type plate heat exchangers: numerical approach
... accuracy of the numerical model used in this study was extensively tested in previous works (Fernandes et ...a numerical approach, Fernandes et al. (2005, 2006) studied the ... See full document
9
On the determination of parameters required for numerical studies of heat and mass transfer through textiles - Methodologies and experimental procedures
... a transfer point of view, an increase in water retention in the fibres implies a decrease in the gas fraction and, thus, a decrease in the thermal resistance [18] ... See full document
11
NUMERICAL MODELING OF HEAT TRANSFER AND FLUID FLOW IN KEYHOLE PLASMA ARC WELDING OF DISSIMILAR STEEL JOINTS
... evolution of temperature profiles and weld pool geometry during dissimilar welding between 2205 duplex stainless steel and A36 low carbon steel using keyhole plasma arc welding has been simulated ... See full document
13
Experimental and Numerical Study of the Impact Behaviour of an Adhesively Bonded Automotive Structure
... goal of showing that adhesive bonding behaves well during crash ...verified in most service situations, allowed to conclude that failure in the specimens bonded with the crash-resistant epoxy ... See full document
132
Experimental investigation on flow and heat transfer for cooling flush-mounted ribbons in a channel: Application of an EHD active enhancement method
... present study, the heat transfer enhancement of a bundle of flush-mounted ribbons placed on the floor of a rectangular duct was investigated experimental- ...as ... See full document
12
Development of an ex vivo model of endovenous laser ablation of the great saphenous vein in a pilot study
... method of endovenous treatment is the best choice, on the other hand it should prompt research on and development of standards for the use of these ...concepts and ... See full document
7
Numerical study of the conjugate heat transfer in a horizontal pipe heated by Joulean effect
... combinations of the Grashof number and the inclination of the tube for all Prandtl numbers between ...0.7 and 7. Numerical experiments carried out for developing flows indicate that the ... See full document
15
Nanosecond ablation of alumina with an ytterbium fibre-laser: experimental study, topography and damage evaluation
... marks and evenly distributed ”holes”, the Wφ 42 set gave rise to a highly irregular, rough ...Measurement of the roughness parameters was not even possible, due to the large non-focusable fraction of ... See full document
75
Numerical and experimental study of a solar hybrid collector for combined production of electricity and heat
... than an unglazed ...2007). An exergy analysis was presented by Morita et ...value of about ...glazed and 11.92% for unglazed PV/T collectors, and the optimum flow temperature is, ... See full document
213
Experimental Study of Heat Transfer Enhancement in a Heated Tube Caused by Wire-Coil and Rings
... effect of different wire coiled geometries on pressure drop during the condensation of R-134 vapor inside a horizontal tube was experimentally investigated by Akhavan-Behabadi et ...(2008). In ... See full document
8
Numerical investigation of fluid flow and heat transfer in a multi-strand steelmaking tundish with closed strands
... Heat Transfer and fluid flow study has been carried out in a multi-strand billet caster curved shape tundish for a situation when the strand is sometimes closed because of ... See full document
10
Numerical Investigation on Heat Transfer of Power Law Fluids in a Pipe with Constant Wall Temperature
... analysis of steady incompressible non-Newtonian power law fluids was first performed by Schowalter [1] and Acrivos et ...formulated, and the conditions of the existence of similarity ... See full document
3
temas relacionados