• Nenhum resultado encontrado

[PDF] Top 20 Numerical and experimental analysis of yield loads in welded gap hollow YT-joint

Has 10000 "Numerical and experimental analysis of yield loads in welded gap hollow YT-joint" found on our website. Below are the top 20 most common "Numerical and experimental analysis of yield loads in welded gap hollow YT-joint".

Numerical and experimental analysis of yield loads in welded gap hollow YT-joint

Numerical and experimental analysis of yield loads in welded gap hollow YT-joint

... analytical, experimental, and numer- ical analysis of plain steel, circular hollow sections welded into a YT ...behavior and failure of the joint are ... See full document

22

Lat. Am. j. solids struct.  vol.8 número2

Lat. Am. j. solids struct. vol.8 número2

... an analysis on the effect of support springs in an ends circular hollow sections welded into a YT ...behavior and failure of the joint were characterized ... See full document

17

Rev. Esc. Minas  vol.66 número3

Rev. Esc. Minas vol.66 número3

... study of welded K joints with gap, formed by a structural steel hot rolled hollow section, having rectangular hollow sections at the chords and circular hollow sections ... See full document

6

Lat. Am. j. solids struct.  vol.12 número11

Lat. Am. j. solids struct. vol.12 número11

... behavior of K- and T-joints with circular hollow sections and estab- lished comparisons between the analytical formulations proposed by Eurocode 3 – Part 8 (2005), the 2 nd edition design ... See full document

16

Increases in the numerical density of GAT-1 positive puncta in the barrel cortex of adult mice after fear conditioning.

Increases in the numerical density of GAT-1 positive puncta in the barrel cortex of adult mice after fear conditioning.

... surface of the section, ...height of the optical dissector, (ii) puncta must lie entirely or partially within the counting frame or they must touch the upper and right borders (inclusion edges) ... See full document

11

Numerical Simulation of Residual Stresses in Linear Friction Welded Joints

Numerical Simulation of Residual Stresses in Linear Friction Welded Joints

... model of linear friction welding has been ...distribution of temperature and stress field during the forging phase was determined by solving the coupled problem in ...effect of welding ... See full document

4

STRUCTURAL ANALYSIS AND CONTROL OF VIBRATING HOPPERS FOR HARVESTED GRAPES IN A WINE CELLAR: A CASE STUDY

STRUCTURAL ANALYSIS AND CONTROL OF VIBRATING HOPPERS FOR HARVESTED GRAPES IN A WINE CELLAR: A CASE STUDY

... excitation of the low ...board and acquisitions were ...range of the motor excitation. The slab modal frequencies and associated damping values have then been identified by implementing a ... See full document

9

Numerical simulation of supersonic gap flow.

Numerical simulation of supersonic gap flow.

... area in the hypersonic flows, in which the present method employs temperature sensitive paint and simple optics installed inside of a model, but the precision of it is still open to ... See full document

16

Mat. Res.  vol.16 número5

Mat. Res. vol.16 número5

... degradation and made up by the nugget and the two HAZs, was ...hardness of the HAZ at the advancing and retreating ...vales and, then, is the weakest zone in the ...properties ... See full document

7

A Strategic Analysis of Search Engine Advertising in Web  based-commerce

A Strategic Analysis of Search Engine Advertising in Web based-commerce

... Most of Indian industries are expanding their business ...popularity of web. Travel Industry has one of the most successful online ...be in the range of Rs 430-540 ...50-55% of ... See full document

13

Analysis of bone damage during drilling processes

Analysis of bone damage during drilling processes

... tissue and the main constituent of the human skeletal ...tissues in rigidity and hardness ...one of the most common public health concerns due to the automobile and motorcycle ... See full document

207

Analysis of Carbon Diffusion during Bainite Transformation in ADI

Analysis of Carbon Diffusion during Bainite Transformation in ADI

... 1 of bainitic ferrite forms without diffusion, but any excess carbon is soon rejected into the residual ...stage of transformation from austenite whose carbon concentration is initially identical to that ... See full document

6

Application of time-series analysis for prediction of molding sand properties in production cycle

Application of time-series analysis for prediction of molding sand properties in production cycle

... noise. In the second case the modeling would be certainly ...One of them is the non-parametric runs-test that verifies a randomness hypothesis for a binary-valued data sequence; in case of ... See full document

5

The Impact of E-Commerce Securi ty, and National Environment  on Consumer adoption of Intern et Banking in Malaysia and  Singapore

The Impact of E-Commerce Securi ty, and National Environment on Consumer adoption of Intern et Banking in Malaysia and Singapore

... ways of performing the same task (Roger, 1983; Agarwal & Prasad, ...day and 7 days a week, it provides an enormous advantage and convenience to users (Tan & Teo, ...products and ... See full document

20

Microscale flow dynamics of red blood cells in microchannels: an experimental and numerical analysis

Microscale flow dynamics of red blood cells in microchannels: an experimental and numerical analysis

... used in our experiment consists of an inverted microscope (IX71, Olympus, Japan) combined with a confocal scanning unit (CSU22, Yokogawa, Japan) and a diode-pumped solid state (DPSS) laser (Laser ... See full document

19

NUMERICAL AND EXPERIMENTAL ANALYSIS OF THE FLOW OVER A COMMERCIAL VEHICLE- PICKUP

NUMERICAL AND EXPERIMENTAL ANALYSIS OF THE FLOW OVER A COMMERCIAL VEHICLE- PICKUP

... interest in aerodynamically optimize pickups is a longtime concern of the ...complete analysis for the development of the 1988 Chevrolet ...length and height and ground ... See full document

95

Lat. Am. j. solids struct.  vol.14 número7

Lat. Am. j. solids struct. vol.14 número7

... series of researchers have collected the test results in literature and have developed empirical and analytical relations to predict the RC joint shear capacity (Pauletta et ...Muhsen ... See full document

26

ANALYTICAL AND NUMERICAL RESEARCH OF WAVE LOADS ON A SHORT VERTICAL WALL

ANALYTICAL AND NUMERICAL RESEARCH OF WAVE LOADS ON A SHORT VERTICAL WALL

... ANALYTICAL AND NUMERICAL RESEARCH OF WAVE LOADS ON A SHORT VERTICAL WALL The problem of wave loads on a relatively short wall is related to the issue of the general design ... See full document

11

Analysis of Structure and Abrasion Resistance of the Metal Composite Based on an Intermetallic FeAl Phase with VC and TiC Precipitates

Analysis of Structure and Abrasion Resistance of the Metal Composite Based on an Intermetallic FeAl Phase with VC and TiC Precipitates

... properties of metals and ceramics. Their low density, high strength and resistance to oxidation, combined with sufficient ductility and fracture toughness, make them an attractive material for ... See full document

4

Braz. J. Phys.  vol.34 número2B

Braz. J. Phys. vol.34 número2B

... (a) Hollow cylinder made of GaAs; (b) Cylinder of InSb covered by a cladding of ...a=50nm and b=100nm. B=5000 G. The dotted line in Fig 1(a) cor- responds to the case without ... See full document

2

Show all 10000 documents...